This page provides instructions for installing the Cisco VPN software (version 4.9.01.0100) for Mac OS 10.4 or later. A system restart is necessary to complete installation.
Acquiring the Installation File
Unless application defaults have been changed, downloading the file should place it on the Desktop, creating a disk image file named UHVPN-4.9.01.0100.dmg.
VPN Software Installation
If you have a previous version of VPN software installed, it must be removed. Look in the Applications folder on the hard drive where VPN is installed. If there is an icon to uninstall VPN, use that. Otherwise, drag the icon for the VPN software from the Applications folder to the trash, and empty the trash. Restart the computer. Now you are ready for installation of the new VPN software.
Open the UHVPN-4.9.01.0100.dmg disk image, if it is not already open. The disk image contents should include Cisco VPN Client.mpkg, and two folders: Profiles and Resources (both empty). Double-click on Cisco VPN Client.mpkg. A series of pop-up windows will appear:
Software License Agreement <Continue>
A drop-down window appears. Click the Agree button.
Select a Destination - Click the hard drive icon to select on which drive the VPN client will be installed, then click the Continue button.
Standard Install on "[drive name]" - Click on the bottom right button. Depending on the install, the button will read Upgrade or Install.
Authenticate - Enter your user password, then click the OK button.
Install Software - Click the Close button when the installation is finished.
Restart the computer.
VPN is configured as part of the installation, so the only thing left for you to do is actually use the VPN software. When prompted for a username and password, use your CougarNet username and password.
In case the configuration file becomes corrupt, profile settings are included below. Delete a profile if you suspect it to be corrupt. To delete the profile, click on the profile entry once to highlight it, then click the Delete button in the VPN window.
Now you are ready to create a new configuration file. Start VPN which opens a VPN window. Click on the New button located near the top of the window, creating a pop-up window. Enter/configure the following information:
NOTE: The password is case sensitive and in all caps.
Confirm Password: UHVPN
Select the IPSec over UDP (NAT /PAT) radio button.
Click the Add button, creating a pop-up window. Enter 184.108.40.206 for the IP address, and click OK, closing the window.
Click the Add button again, creating another pop-up window. Enter 220.127.116.11 for the IP address, and click OK, closing the window.
Click the Save button. VPN is now ready to be used.
For More Information
For any additional questions, problems, or concerns, please contact the IT Support Center at 713-743-1411 or via email at firstname.lastname@example.org.